Planning and Materials
Cost
Hot Wire Foam Cutter
Cutting the foam
Refining the shape
Applying the epoxy filler
Springboard tunnel
Hard points and reinforcements
| Seatbelt attach
point Plank rope assembly attach point Mast base attach point Sheave attach point |
Plank Attach Plates
Pedals System
Pedal Slots |
Rear Plank
Runners
Paint
Final Assembly
Photo Gallery
Impressions
Refining the Shape
After about 30-40 hours of carving and sanding the boat is starting to
take shape
You can see the extra foam block left over. The nose has been glued on
and shaped.
